|
Add new comment
| mr fitz |
07.Aug.2015 15:44:58 |
| The "ready" position. The steel rod is connected to the rotating target with some cable. That is attached to a bolt eye (round circle at end of a bolt) on the ABS pipe about 3 inches from its pivot point (the eye is not visible). If you wanted to set up the dunker to trigger conterclockwise the eye bolt would be reversed - so the eye is located on the opposite side of the target shaft. This would be how a traditional dunk tank is set up with the dunker facing the dunkee. |
|
|
